Injectable Anabolics.

Buy Injectable Anabolics Online — Domestic USA

Every oil on this page ships from inside the United States. Brewed by Fury Pharma, dosed to label, no customs and no three-week wait.

Esters, in plain terms

The ester is the only meaningful difference between most of these compounds. It controls how fast the drug releases and therefore how often you pin. Test P and Tren A are short esters; Test E, Test C, Deca and EQ are long. Match your injection frequency to the ester, not to preference.

What to look for in any source

Three things: dose accuracy, sterile filtration, and a lab test. We support Janoshik testing — send a batch in and get store credit back.

Your ester decides your schedule, not your preference

Everything on this page is the same handful of parent hormones attached to different esters. The ester does one job: it sets how fast the compound releases, and therefore how often you pin. Get that wrong and you spend the cycle chasing unstable levels.

Higher concentration brews mean less oil per dose, which means less pain. It also means more solvent, which is why the 200mg/mL and 300mg/mL products sting more than the 100mg/mL ones.

Test E, Test C or Test P?

Test E and Test C are the same parent hormone with a half-life that differs by under a day. Anyone insisting one is cleaner or holds less water is guessing; the ester changes release rate, not behaviour. Pick whichever you can get consistently and stay on it.

Test P is the one real difference. At ~2 days it clears fast, so if something goes wrong you are back to baseline in days rather than weeks. The price is pinning every other day at minimum.

First cycle, no experience: Test E or Test C, 300-500mg per week, 10-12 weeks, split across two pins. Add nothing else for the first four weeks so you know what is doing what.

Tren: acetate or enanthate

Acetate. It is more frequent pinning, and that is the point: Tren side effects arrive fast and hard, and a short ester lets you back off and recover in days. Tren E is for people who already know their tolerance and would rather pin twice a week.

Tren is not a beginner compound despite the popularity. Run it alone first, at 200-300mg per week, before stacking it.

Carrier oil: MCT

Every oil on this page is brewed in MCT (medium-chain triglyceride). No blends, no exceptions. It is published on every product page as a spec, so you can check the vial you receive against it.

MCT is the thinnest common carrier. It flows through a 25g without heating, which means a faster push and less post-injection pain than a heavier oil. That is the whole reason it is used here: PIP is the most common complaint in this market and carrier is the single biggest lever on it.

Two practical notes. MCT is coconut-derived, so if you react to coconut, start with a small volume in one site rather than a full millilitre. And because it is thin, a slow push matters more, not less — the oil clears the barrel faster and it is easy to go too quick.

Unopened vials are good for 2 years from brew date. Once punctured, use within 8 weeks.

Pinning, in practice

Needles: 25g x 1 inch for glutes and ventroglutes, 25-27g x 5/8 inch for delts and quads. Draw with a larger gauge, then swap to a fresh needle to pin; a used needle is duller and tears more.

Sites: glutes, ventroglutes, delts, quads. Rotate. Never pin the same spot twice in a row. 1mL per site is a sensible ceiling, which is another reason to split a weekly dose.

Technique: swab the stopper and the skin, let it dry, push slowly. A slow push is the single biggest factor in reducing post-injection pain.

PIP, and what actually causes it

Post-injection pain is almost always one of four things: too much oil in one site, too much solvent, pinning too fast, or virgin muscle that simply is not used to it. Warming the vial and slowing the push fixes most cases. The first few pins into any new site will be the worst ones.

Injectables FAQ